CNC Technology                                                          

VAKUFIT Universal-Vacuum-Clamping-System
The Vacuum Clamping System for Initial Equipment and Backfitting.

General:

The isel VakuFit clamping system solves clamping problems easely and quickly. It can be used on all T-groove plates and does not depend on rasters.

All isel machines can be upgraded and backfitted with this vacuum clamping technology in a very cost-saving way. It can also interact with different clamping technologies of all kinds.
It is recommended to use an injection pump to create the vacuum. The pump is maintenance free and uses regular compressed air between 4 and 8 bar.

The time between applying and clamping of a part is less than 2 seconds (up to 85 % vacuum).
Two different vacuum pumps are provided. One pump has an energy saving function, wich stops the compressed air supply on an optionally adjusted vacuum, so that it only uses air for about 5 seconds per clamping procedure. The second pump is without any further functions. It has a permanent air consumption. Both provide a vacuum of approximately 85 %.

The pump with the energy saving function also contains a blow off function for a quick loosening of parts and a vacuum monitor. This pump is especially qualified for professional applications.
The basic pump without any further functions is qualified for conditions of short-term applications while it is consuming compressed air permanently.
isel offers basically two basic versions for the VakuFit clamping system - as you can see adjoining.

The isel VakuFit clamping system solves almost every clamping task on isel machines and devices for an especially favourable price/performance ratio.

General information as well as ordering data (approx. 3,4 MB)

Copyright © 2009 Micromech Ltd. All rights reserved.