 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
|
Multi-Axis Motion Controllers
The MAXp is a PCI bus-based motion controller with up to 8 axes of user-definable servo & stepper motion control. The MAXp is built on a PowerPC 32-bit RISC processor running at 266 MHz. The use of this processor delivers exceptional servo control, capabilities, quality, and application performance on multi-axis requirements. All signals, data points, and the PID loop update every 122µs on all 8 axes. Each axis of the MAXp controller can be configured as a servo, open loop stepper, or a closed loop stepper.
Features
- PID update rate of 122µs on all 8 axes
- 266-MHz, 32-bit RISC processor
- 64k Shared Memory
- PCI Universal Bus-3.3V or 5V
- 8 Mb system memory
- 4 Channels of general purpose Analog Input, with 16 bit, 0-10 VDC input
- Support Quadrature Encoder feedback up to MHz.
- Backlash Compensation
- Linear, Parabolic, Cosine "S" - curve and custom profiles.
- Real time encoder position capture.
- Circular interpolation
- Firmware upgrades and enhancements
- Field upgradable firmware
- Opto-isolated Digital I/O. High-density shielded 120-pin connector.
Accessories:
IOMAX - I/O breakout board w/out cable
CBL120-3M - 3 meter cable w/mating connector, 120-pin
CBL25-10 - 10 ft cable w/mating connector, 25-pin
| Model | Computer Interface | Axes | SERVO / STEPPER AXES Servo / Open or Closed loop Stepper |
User I/O |
| MAXp-1000 | Universal PCI | 1 | User-Definable | 17 |
| MAXp-2000 | 2 | User-Definable | 18 | |
| MAXp-3000 | 3 | User-Definable | 19 | |
| MAXp-4000 | 4 | User-Definable | 20 | |
| MAXp-5000 | 5 | User-Definable | 21 | |
| MAXp-6000 | 6 | User-Definable | 22 | |
| MAXp-7000 | 7 | User-Definable | 23 | |
| MAXp-8000 | 8 | User-Definable | 24 |
Copyright © 2009 Micromech Ltd. All rights reserved.
|